Plastic Welding Machine / Laser Plastic Welding Machine / Hot Air PVC Banner Welder
1. The overall weight of the machine increased, with a better effect of pressure!
2. Power switch with front knob type, more convenient operation!
3. Wind gun fixed block, adopthook-type, easier than the previous hand-operated!
4.Adopt3400W high-power air gun, the whole power 3600W, to ensure the effect of splicing under the premise of the actual width of the welding widening!
5. Exclusive design, splicing + package rope one round, not only can be stitching, but also package rope / package edge!
6. The king of splicing speed, in order to ensure splicing 520/550 inkjet cloth effect under the premise of the fastest 15 meters per minute, is the inkjet processing plant Gospel!
1. Small size, light weight and easy to carry
2. Digital display function
3. Wind is adjustable
4. Welding speed is fast
5. Do not have fold during the welding process
6. Having press-wheel, it is easy to move
7. Laser precision positioning system
1. Any part of this machine being bumped of fallen can cause some damage impossible to be repaired.So please pay attention to carry it.It is suggested to move the machine by manpower and put it down carefully.
2. Please check if there is damage or missed parts after unpack the machine.Any problem, please contact us or the local agent immediately.
3. The place for installation must be flat and the floor is strong enough to support the machine and moreover, the installation place should close to power supply.
4. Keep the installation place no dust and avoiding sunshine.
5. Please sweep away the anti-rust oil from the machine with detergent and re-lubricate with light lubricating oil after installation.
1. Make the cloth for seaming flat and tight,. take joiner to accurate (about 2-4cm),Fix both ends by tape or glue on ground.
2. set the temperature and walking speed: Connect the power supply, set the temperature and walking speed according to the thickness of the cloth. Temperature and speed is adjustable. As shown:
3. Turning the heating switch (yellow knob), the machine starts to heat up. Wait for 2 minutes,when actual temperature (PV)approach desire temperature(SV),we can start weld.
4. Welding positioning. Lap welding pressure(working wheels)- wheel edge must be aligned with the upper edge of the banner
4.Lifting the handle, making the working wheel on ground,as the show
6. start welding: pulling the heat gun to position handle and making the nozzle close to ground then move the nozzle to left so that it can be place a right position, at that time, the welding will work automatic.
7. During welding,let hot air nozzle between two overlap pieces. And be make sure hot air nozzle and Rubber wheel walk in straight line.if not,please adjust by handrail.check photo:
8. finishing welding: when we finish these work, pull the handle shake, turn right to move out nozzle until stops rotating nozzle upwards and it is locks.
9. Turn off the switch: when finished, turn off the yellow knob,shut off main power supply when the PV value is less than 50 degree.then we can turn off the power.
For first-time users, you can get a piece of scrap cloth to measure the temperature of the required , test methods are as follows:
Making quickly the cloth next to the nozzle, if there is a burning cloth, it shows the temperature at this time is possible. the effect of welding should be as follows: