# # Operation at 2.970Gbit/s, 2.970/1.001Gbit/s,1.485Gbit/s, 1.485/1.001Gbit/s and 270Mbits/s
# Equalized and re-clocked loop output
# Auto video mode detection (3G/HD/SD)
# Conversion from SMPTE 425M level B to Level A 1080p 50/59.94/60 4:2:2 10-bit
# Connect with other units to extend your signal over long distances
# Simultaneous display with SDI /AV signals
Note: Cable tested with Belden 1694A. Operating distances may vary if used with another type of cable.
3G SDI to AV Sclaer Converter
5V DC Power Supply Adaptor
- - - -
SMPTE Standard | 425M Level A & B, 424M, 292M, 259M-C |
SDI Transmission Rates | 2.970 Gbit/s and 2.970/1.001 Gbit/s |
SDI in/out Resolution | SD: 480i@60, 576i@50
HD:720p@50/60, 1080i@50/60 3G:1080p@24/25/29.97/30/50/59.94/60 |
CVBS Output Resolution | PAL/NTSC-M |
Input Port | 1 x BNC (SD/HD/3G-SDI) |
Output Port | 1 x BNC (SD/HD/3G-SDI), 3 x RCA (CVBS,L/R) |
Power Supply | DC 5V -12V |
ESD Protection Human body model | 8kV (air-gap discharge) ,
4kV (contact discharge) |
Dimension | 95mm x 60mm x 25 mm |
Weight | 260g |
Operating Temperature | 0C ~ 40C / 32F ~ 104F |
Storage Temperature | -20C ~ 60C / -4F ~ 140F |
elative Humidity | 20 ~ 90% RH (Non-condensing) |
Power Consumption (Max) | 5W |
- - - -
Operation controls and Fuctions
SDI IN: This slot is where you connect the SDI source output for SDI signal sending to be display on screen.
SDI OUT: This slot is where you connect the SDI display with SDI cable for input source display.
POWER LED: This red LED will illuminate when the device is connected with power supply.
DC IN: Plug the 5V-12V DC power supply into the unit and connect the adaptor to AC wall outlet.
CVBS out format: Press this switch to select the CVBS output format .
AV output: This slot is where you connect the TV with RCA calbe.