Hotel Way Healthier Ionic / Ozone Dual Air Purifier Low Power Consumption
Negative ions are considered the vitamin of the air. Molecules usually carry a neutral charge; however, when molecules lose an electron, they become anions (negatively charged ions). Anions are relatively unstable, and will attract and trap any free electron pairs. As a result of this attraction, small air pollutants and dust molecules bind with anions, producing an air purifying effect.
The EP200 negative ion air purifier is compact in size, technologically advanced, and is capable of purifying air. It is suitable for use in places such as the bed room, living room, garage and storage etc. It generates a sine wave high voltage, which is applied to two stainless steel pins thus releases negative ions. These negative ions are relatively free from harmful NOx molecules, unlike the ions produced from using high voltage pulses. Because of the simple waveform used, the device gives minimal interference to nearby electrical appliances. This unit also generates a small amount of ozone which is well below the international health safety standard of 0.08ppm over 8 hours.
- - - -
High output of negative ions at above -6kV |
Stainless steel pin electrodes |
Flashing neon to indicate output pulses and battery status |
Ultrasonic frequency waves at about 30kHz |
High ozone output using twin ozone generating tubes, <0.08 ppm over 8 hours |
Effective area 10-15(100-150 ft sq.) |
Brushless long live D.C fan to blow ozone out of casing |
Power consumption: <300mA at 6V D.C |
Dimension: 76 6383mm(3 2 1/2 3 1/4)
- - - -
- - - -
MinimumOrderQuantity: | 100pcs |
Price: | negotiation |
PaymentTerms: | T/TorwesternUnion |
SupplyAbility: | 1000000pcspermonth |
DeliveryTime: | 10-20workingdays |
PackagingDetails: | Packedincartonfirstly,andthenreinforcedwithcaseforouterpacking |
- - - -
1. Push the battery cover downwards to open. Install four alkaline AA batteries into the battery compartment. (The terminal with a spring is the negative terminal.) Replace the battery cover.
2. For continual indoor use, use the power adaptor supplied:
a. Use the two screws provided to fit the mounting bracket onto the back of the unit
b. Insert the round shaped outlet of the power adaptor into the only socket at the back of the unit, and plug the other end to an appropriate electrical socket on the wall.
3. Place the unit at a convenient position so that the negative ions and ozone will be most effectively dispersed throughout the room.